NC-80 computer cross cutting machine
- ※Structural features:
★The base of the main unit and the wall panel are made of gray cast iron, which has good rigidity and strong vibration resistance.
★The German Kobe servo controller controls the motor drive, and the Taiwan Eview 10.4-inch color tou...
- Inquiry Hotline: 13903279305
-
Product Details
※Conventional technical parameters:
1. Maximum working width: 1600mm
2. Operation direction: left or right (according to customer's factory)
3. Maximum mechanical speed: 80m/min
4. Mechanical configuration: computer straight knife cross-cutting
5. Minimum paper cutting length: 500mm
6. Maximum paper cutting length: 9999mm
7. Paper cutting precision: the uniform speed is ±1mm, non-uniform speed is ±2mm
※ Roller diameter parameters:
1. The center distance of the upper and lower knife shafts for cross-cutting: ￠216mm Balance treatment
2. Diameter of front and lower conveying roller: ￠156mm Do dynamic balance treatment
3. Diameter of rear and lower conveying roller: ￠156mm Do dynamic balance treatment
4. Diameter of front upper platen roller: ￠70mm
5. Diameter of front upper platen roller: ￠70mm
Note: After all rollers are ground, the surface is plated with hard chrome (except upper and lower cutter shafts)
※Power motor and electrical parameters:
1. Main drive motor power: 11KW 2. Front and rear paper feeding motor power: 3KW
1. Maximum working width: 1600mm
2. Operation direction: left or right (according to customer's factory)
3. Maximum mechanical speed: 80m/min
4. Mechanical configuration: computer straight knife cross-cutting
5. Minimum paper cutting length: 500mm
6. Maximum paper cutting length: 9999mm
7. Paper cutting precision: the uniform speed is ±1mm, non-uniform speed is ±2mm
※ Roller diameter parameters:
1. The center distance of the upper and lower knife shafts for cross-cutting: ￠216mm Balance treatment
2. Diameter of front and lower conveying roller: ￠156mm Do dynamic balance treatment
3. Diameter of rear and lower conveying roller: ￠156mm Do dynamic balance treatment
4. Diameter of front upper platen roller: ￠70mm
5. Diameter of front upper platen roller: ￠70mm
Note: After all rollers are ground, the surface is plated with hard chrome (except upper and lower cutter shafts)
※Power motor and electrical parameters:
1. Main drive motor power: 11KW 2. Front and rear paper feeding motor power: 3KW
Previous article: ZQS thin knife lifting slitting and creasing machine
